What To Do If - Atag VA9111RT Benutzerinformation

4. Clean the filters below running water.
5. Put the flat filter (C) in the bottom of the
appliance.
6. Put the coarse filter (A) in the microfilter
(B) and push the filters together.

What to do if...

The appliance does not start or stops during
operation.
Malfunction
The appliance does not
fill with water.
The appliance does not
drain the water.
The anti-flood device
operates.
The programme does
not start.
Fault code
The display shows
The display shows
The display shows
7. Put the filter system in position.
8. To lock the filter system, turn the handle
on the microfilter (B) clockwise until it
locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
cocktail stick.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(e.g. acetone).
First try to find a solution to the problem (refer
to the chart). If not, contact the service cen-
tre.
Possible cause
The water tap is
blocked or is furred with
limescale.
The water pressure is
too low.
The water tap is closed. Open the water tap.
The filter in the water in-
let hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose is
damaged.
The appliance door is
open.
Possible solution
Clean the water tap.
Contact your local wa-
ter authority.
Clean the filter.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter drain hose has no
damages.
Close the water tap and
contact the service
centre.
Close the door correct-
ly.
37