Troubleshooting - Abicor Binzel TIG ABITIG WH Serie Betriebsanleitung

®
ABITIG WH
9.3 Cleaning the changeable body

10 Troubleshooting

Fault Cause
• Power supply to the work-piece or torch
No arc
• Fault with power supply or control lead.
• Control lead interrupted
• Contactor not activated in the power supply. • See operating instructions for
No arc
• Inadequate flow of coolant.
Torch body or
power supply
• Welding current too high.
cable
• Coolant hose or liquid-cooled power cable
overheated
• Tungsten electrode loose.
Tab. 10 Troubleshooting
1 Clean coupling parts and slightly grease them with silicone-free sealing
grease.
2 Check clamp clip for visible damage and replace the complete changeable
body, if required.
NOTE
• Maintain the contact area between the torch neck and the changeable
body flat and free of soiling.
• When mounting the insulating jackets, make sure that no control leads
are caught between the two halves.
NOTE
• If the measures described below are not successful, please consult your
dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power supply.
interrupted.
constricted or closed.
10 Troubleshooting
Solution
• Close the electric circuit
• Repair
• Replace it
the power supply
• Check that the coolant
recirculator is working and
performing correctly.
• Reduce.
• Check the flow and replace if
necessary.
• Tighten
EN - 19