Abicor Binzel TIG ABITIG WH Serie Betriebsanleitung Seite 30

6 Putting into operation
6.1 Equipping the TIG welding torch
1
5
1 Torch body
2 Gas nozzle
Fig. 2 Equipping the torch
EN - 10
CAUTION
Risk of injury
Puncture wound may be caused by sharpened electrode tip.
• Do not reach into the danger zone.
• Wear protective gloves.
NOTE
• The torch equipment depends on the material to be welded. The required
amperage determines the electrode diameter. Please see the current
order documents for a correct selection of the equipment parts.
• Instead of the electrode holder, you may also use a gas diffuser that
produces a laminar gas flow due to its design.
Equip the torch neck according to one of the following figures:
Step 1 Step 2-3
4
3 Tungsten electrode
4 Torch cap
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder (5) from the front.
3 Hold the tungsten electrode (3) and the electrode holder (5) and screw on
torch cap (4).
4 Screw gas nozzle (2) onto torch body (1).
Step 4
3
5 Electrode holder
®
ABITIG WH
2