Abicor Binzel TIG ABITIG WH Serie Betriebsanleitung Seite 35

®
ABITIG WH
6.8 Manual torch neck change
Fig. 6 Manual torch neck change
6.9 Automatic torch neck change
1.
2.
3.
NOTE
• Do not change the hand lever position during the change procedure!
This will result in malfunctions.
1 Insert hand lever through the cover into the bore.
2 Move the hand lever forwards in the direction of the torch neck past the
pressure point to the stop and take out the torch neck.
3 Insert torch neck into changeable body as far as it will go.
4 Push the hand lever toward the rear up to the stop and take it out, after
locking it.
The ATS rotor torch change system is a peripheral device that performs the
torch neck change during the fully automatic welding process. Request order
documentation on this or consult special documents for the exact procedure.
6 Putting into operation
5.
4.
EN - 15