Samsung MX-T70 Handbuch Seite 16

2. Connect the RCA cable to the AUX2 OUT on the MAIN and AUX2 IN on the SUB as shown by using
the RCA cable (not supplied).
3. In "BT" mode, press the "AUX" button on the MAIN Sound Tower remote control for at least 5
seconds. "SEARCHING TV STEREO" appears on the display.
4. When the connection is complete, "TV STEREO MODE" appears in the display and then the current
output CHANNEL is displayed.
5. When the connection is complete, a "SEARCHING TV" message appears in the MAIN Sound Tower
display and a "SUB" appears in the SUB Sound Tower display.
• The MAIN Sound Tower outputs the left channel sound and the SUB Sound Tower outputs the
right channel sound. Press the ADD STEREO button on the MAIN or SUB Sound Tower to
change the sound channel of the Sound Tower.
6. Connect a TV and MAIN Sound Tower via Bluetooth to play music. Sound is output from both
Sound Tower.
NOTES
• To use Stereo Group mode, both Sound Tower must be the same model.
• A red light on the LED on the ADD STEREO button indicates an error in the Stereo Group
connection. Try Step 1 to 5 again.
• In Stereo Group mode, the remote control, BT PAIRING, GROUP PLAY, and
the SUB Sound Tower are disabled.
• The GROUP PLAY button on the MAIN Sound Tower is not available in Stereo Group mode.
• If Samsung TV supports a simple connection, the connection pop-up is automatically displayed on
the TV, and if you select "Yes", it connects to the TV. If there is a previous connection history
between Samsung TV and Sound Tower, it will be connected to Samsung TV without pop-up. For a
simple connection to Samsung TV, refer to page 17.
• The lighting colours may vary between the MAIN Sound Tower and the SUB Sound Tower.
• When connecting to a TV, the names of the MAIN and SUB Sound Tower are the same in the
Bluetooth list on the TV, and only the MAIN Sound Tower can be connected.
Terminating the Stereo Group mode connection
Press the ADD STEREO button (MAIN or SUB) for at least 5 seconds after the Stereo Group is
connected.
• "OFF-STEREO MODE" appears in the display and the LED on the ADD STEREO button turns off.
ENG - 12
(Source) buttons on