Installation And Use; Safety Instructions; Use - Casselin CBMS1 Handbuch

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Risk from electrical current!
• No contact with heat sources must take place with the power cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water in the unit in operation or still hot.
• The device must be connected properly and comply with regulations.
WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use the
machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be fully
withdrawn.
Place on a solid, flat surface.
Do not install this device near open fires or other heating appliances.
The product is ready for use.
USE
Pour the liquid into the tank up to the level indicated Max inside the tray.
The sauce level must not be lower than the level Min. The device must not be used without liquid.
Plugging in, the orange LED will illuminate.
Turn the thermostat in the direction of clockwise to the desired setting.
The temperature may be between 30 ° and 90 ° C.
When the selected temperature is reached, the green LED lights and LED orange off.
When the temperature drops, the appliance starts to heat up and the orange light comes on again.
At the end of use, unplug the appliance and clean it according to the cleaning instructions.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.
EN