Gewa HC14 Bedienungsanleitung Seite 10

4 A I
SSEMBLY NSTRUCTIONS
Assembly top cymbal
Figure 1
Assembly bottom cymbal
Figure 3
HC14 cable connections – Trigger Type Dual
Figure 4
Unscrew the bottom nut (D) from the Hi-Hat
1
Clutch (A).
Attach the spin lock (B) to the shaft of the top
2
part of the clutch (A).
Guide clutch and spin lock through the middle
3
hole of the Top Cymbal (C).
Orient the spin lock (B) inside the cymbal mold
4
as shown in Figure 2.
Screw the bottom nut (D) onto the shaft of
5
Clutch (A) again and clip the clutch bumper (E)
on the bottom nut (D).
Lightly clamp the cymbal by fastening the top
6
Figure 2
nut (A).
Remove any felt padding from the Hi-Hat seat (M) of the stand (see al-
1
so compatible stands).
2
Place the steel washer (I) on the seat.
(Optional) Only for Hi-Hat seats without pin (J): Attach the universal
3
cymbal seat (I) to the hi-hat cymbal seat (M).
Place the rubber washer (H) on either cymbal seat or universal cymbal
4
seat.
Guide the Hi-Hat Controller (G) over the Hi-Hat rod (L) and align hole
5
(K) with pin (J).
Place the Bottom cymbal (F) on the controller (G) and match the pro-
6
files around the middle hole.
Loosen the clamp of the Hi-Hat stand top tube and orient the whole
7
system. Arrow (A2) on the bottom cymbal should face the player. With
the correct orientation, fasten the tube clamp again.
Take the top cymbal (C) and connect the stereo cable (angled – an-
1
gled) to the jack closest to the middle hole (see Figure 4).
Guide the cable through the hole of the bottom cymbal which is
2
closest to the Hi-Hat rod.
Align the arrows (A1) and (A2) and guide the top cymbal over the Hi-
3
Hat rod, so that both cymbals rest on top of each other.
4
Straighten the cable carefully if needed.
Connect the straight plug of the Stereo Controller Cable to the Hi-Hat
5
Controller as shown in Figure 4.
Connect both cables to the corresponding Trigger Inputs of your drum
console as shown in Figure 4.
6
The naming convention regarding trigger Inputs might vary from man-
ufacturer to manufacturer, but always offer individual inputs for Cym-
bal and Controller.
HC14 | HC14-AC | HC14-T - Owner´s Manual
7