Fluval FLEX Serie Bedienungsanleitung Seite 7

Component List
6
8
Installing your Aquarium
1. Thoroughly rinse the aquarium, cover and remove media
from poly bags and rinse using fresh water and a damp
cloth. Never use soap on any component placed in
your aquarium as soap is harmful to fish.
NOTE: Place aquarium on a level, sturdy surface;
away from any electrical equipment, direct sunlight,
drafts, heat sources or high traffic areas. Position Anti-slip
pad on surface first before placing aquarium.
2. Position filter media (A), pump (B). Affix pump to tubing
and lower into corner of
rear chamber. Next, feed
the output nozzle through
the hole in the filter wall
and screw into elbow
3. When filling aquarium
with water, add the
correct doses of Fluval
Water Conditioner,
tap water conditioner
and Fluval Biological
Enhancer, biological
aquarium supplement
(all sold separately).
NOTE: Consult with your fish dealer for proper
species and fish stocking levels.
If adding a heater, affix into pump chamber as
shown. (Sold separately)
4
3
2
7
.
1
10
5
B
1. Glass Aquarium
2. Anti-slip Pad
3. Molded Cover
4. LED Light Unit
5. Circulation Pump with
Output Nozzle
6. Foam Filter Block
7. Activated Carbon insert
8. BIOMAX insert
9. Safe, Low Voltage
Transformer (for the
lighting unit)
10. Remote Control
9
A