English - IKEA RODULF 2270990 Handbuch

English

An electro-mechanically height adjustable work-surface with
control interface to adjust height up and down.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved
by a person responsible for their safety. Children shall not play
with the appliance.
Cleaning and user maintenance shall not be made by children
without supervision.
Advice and instructions for RODULF.
This desk shall only be used together with the
controller included.
It is the responsibility of every person who installs,
uses, repairs or services this desk to carefully read
these instructions. Keep these instructions close to
your sit/stand desk.
Installation instructions
• The desk is assembled according to separate
assembly instructions.
• Connect the cable from one leg to the other.
• Connect the electrical cable to a wall socket.
NOTE! The electrical cable must have full mobility.
• The desk is now ready for use.
• The motors stop automatically when the desk
reaches its lowest or highest position.
Use of the desk
• The desk shall only be used as a work desk that
can be continuously adjusted between sitting and
standing position. The desk shall only be used
indoors and in a dry premises (office environment
or similar).
The desk must not be overloaded – the
maximum load is 80 kg/176 lb. The system may
be run continuously for maximum 1 minute. The
motors must rest for approximately 9 minutes it
can be used again.
QUICK GUIDE
Manual reset / first use:
• Perform a reset by simultaneously pressing the
up and down buttons for at least 8 seconds. Keep
holding the buttons and the desk will slowly move
to the lowest possible point. Reset is complete
when the desk has stopped at the lowest point.
Follow these instructions when adjusting
desk height:
1. Make sure no objects are in the way of the desk
height adjustment range.
2. In order to run the desk up or down, press the
man oeuvre button up or down, respectively.
Press the up button and continue to hold until
desired desktop height is reached.
Press the down button and continue to hold until
desired desktop height is reached.
4