Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 5

ENGLISH

1x
1x
1x
WALL ANCHORING GUIDE:
The hardware you should use to secure your
chest of drawers to the wall depends on both the
type of chest of drawers you have and your wall
material.
Type of Wall Material: Using the guide below,
identify your wall material and the appropriate
steps to take for that wall material.
Drywall or plaster with available wood stud:
Mark the attachment point(s) with a pencil at
the appropriate height and positioned over
wood stud(s).
Drill 1/8-inch (3mm) diameter pilot hole(s)
into the wood stud(s), at the height you
marked with pencil.
Drywall without available wood stud:
Mark the attachment point(s) with a pencil at
the appropriate height.
Drill 5/16-inch (8mm) diameter hole(s)
through the wall at the height you marked
1x
2x
with pencil.
Drive the plastic plug(s) into the hole(s), us-
ing a hammer if needed.
Masonry:
Mark the attachment point(s) with a pencil at
the appropriate height.
Drill 5/16-inch (8mm) diameter hole(s) 2 and
3/4-inches (70mm) deep into the wall at the
height you marked with pencil.
Drive the plastic plug(s) into the hole(s), us-
ing a hammer if needed.
If your wall material is not listed here, or if
you have any questions, consult your local
hardware store.
4

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis