Change Of Battery - Elkron KP200 Installation

Panic Alarm — Press 1 + 3 simultaneously at the same time. Red TX LED will flash 5 times and
the Keypad sounds a long beep.
Fire Alarm — Press 4 + 6 simultaneously at the same time. Red TX LED will flash 5 times and
the Keypad sounds a long beep.
Medical Alarm — Press 7 + 9 simultaneously at the same time. Red TX LED will flash 5 times
and the Keypad sounds a long beep.
For wrong entering or operating the Keypad will sound 4 short beeps.
Arm/ Home without PIN Code
Arm Mode: Press
Home Mode: Press
Disarm Mode: Enter anyone of Control Panel user codes and
times and the Keypad sounds 2 beeps.
Enter Test Mode — Enter Keypad PIN code and press ＊ key. The Keypad will sound 1 long
beep and Green Active LED flashes steadily.
Panic Alarm — Press 1 + 3 simultaneously at the same time. Red TX LED will flash 5 times and
the Keypad sounds a long beep.
Fire Alarm — Press 4 + 6 simultaneously at the same time. Red TX LED will flash 5 times and the
Keypad sounds a long beep.
Medical Alarm — Press 7 + 9 simultaneously at the same time. Red TX LED will flash 5 times
and the Keypad sounds a long beep.
For wrong entering or operating the Keypad will sound 4 short beeps.

CHANGE OF BATTERY

1. Put the Control Panel to programming menu.
2. Dismount the Keypad by first removing the slide-out sections then the mounting screws.
3. Open the Keypad by loosening the 2 fixing screw located behind the Keypad.
4. Take out the old battery and wait for 5 minutes before replacing the new battery in the battery
compartment, with unmarked (negative) side of battery facing down.
5. Close the case using the rear fixing screws.
6. Screw back the Keypad to the surface with mounting screws, and then re-insert the slide-outs.
7. Put the Control Panel to exit Programming Menu.
APPENDIX
If you have forgotten the Pin Code or anything wrong happened in the Keypad, you can reset the
Keypad to factory default and reinitialize it.
Reset to factory default:
Step 1 Remove one of the batteries and release the tamper.
Step 2 Press 3 while inserting the removed battery back in.
Step 3 Continue pressing 3 until 3 short beeps to indicate successful reset.
Step 4 Release 3.
Note:
After reset, PIN code reverts to factory default values, "0000". Keypad will need a new learn-in process
to start functioning.
key. Red TX LED will flash 5 times and the Keypad sounds a long beep.
key. Red TX LED will flash 5 times and the Keypad sounds 3 beeps.
4/12
Key. Red TX LED will flash 5