Elkron KP200 Installation

GB
IDENTIFYING THE PARTS
Green Active LED
Red TX LED
Orange Fault LED
Slide Out Section
Arm Key
Home Key
Key
Disarm Key
# Key
LED INDICATOR
•
Green Active LED
o Green Active LED on: the system is in Normal Operation Mode.
o Green Active LED flash: the system is in Test Mode.
o When the Keypad is idle, all LEDs are off. After any key press, the Green Active LED
turns on for 5 seconds indicating that Keypad is active.
o The Green Active LED will turn off after successful completion of a valid keystroke
sequence or when the pause in between key stokes is longer than 5 seconds.
o When the Green Active LED turns off before a valid keystroke sequence is completed
(5 seconds), the previous entered keys are ignored.
•
Red TX LED
The Red TX LED flashes 2 times: the signal is transmitted.
o
REMOTE KEYPAD (KP200)
C L A V I E R D I S T A
C L A V I E R D I S T A
F E R N T A S T A T U
F E R N T A S T A T U
press both 7 and 9 to trigger emergency alarm
press both 4 and 6 to trigger fire alarm
press both 1 and 3 to trigger panic alarm
1/12
N T (KP200)
N T
R (KP200)
R
Key
+ Key
Fire Key
A Key
Mounting Hole
Tamper Switch
Buzzer
Battery Insulator
DS80KP82-001A
LBT80627