Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work, please check the power supply and the
input voltage.
2. In Stand-Alone operation, if the power supply indicator is light up and sound active indicator isn't light up, but the
laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active, please increase the music volume or
increase audio sensitivity with sensitivity knob, please check as below.
B. Please check if unit has been set up in slave mode, then set up in master mode.
3. In Master-Slave operation, slave unit don't function, please check as below.
A. Make sure to there's only one master in the chain, and the others are set in slave mode.
B.Make sure to take a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator is unlighted, please check as below.
A. Make sure to set up the DMX mode.
B. Make sure to have a good connection.
5. In DMX operation, the unit can't be controlled by the DMX console, but the DMX signal indicator is flashing,
please make sure the DMX console and unit have the same channel.
6. If the output beam direction above isn't the right way, please restart the unit.
7. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
8. In PC mode operation, the laser is OFF after the swimming fish, please check as below
A. Please press the button of animation
B. Make sure the SD card is insert with good connection
After trying the above solution you still have a problem, please contact your dealer or our company for service.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
Lire attentivement le manuel avant la première mise en service et le conserver pour référence ultérieur. Cet
appareil a quitté l'usine en parfait état après avoir passé une série de contrôles de qualité très stricts.
Vérifiez le contenu à l'ouverture de l'emballage
CARACTERISTIQUES TECHNIQUES
1. Alimentation: 110/220V, 50/60Hz, Fusible : 2A/250V
2. Consommation : 100W
3. Diode laser: DPSS, vert 532nm 100mW, rouge 650nm 300mW,
bleu 450nm 600mW
4. Puissance du laser : 1000mW
5. Moteur : Scanner haute vitesse 20 kpps
6. Modes de fonctionnement: Activation audio, automatique, DMX, ILDA
7. Canaux DMX : 12
8. Dimensions : 340 x250 x 150mm
9. Poids net : 4kg
10. Poids brut : 4,5kg
©Copyright Lotronic 2013
F
MANUEL D'UTILISATION
IBIZA1000
5
Werbung
