Sonik GIZMO Bivvy Bedienungsanleitung Seite 4

DELAY TIME CONTROL
After activation by an alarm head the light illumination time can be set.
In standby mode, press delay time button to cycle through the delay time
settings. The centre blue indicator LED will illuminate to show the level
selected. There are 6 levels; 5-10-15-20-30-40 seconds respectively.
SYNCING BIVVY LIGHT TO ALARMS
The Sync button is located immediately above the battery cover release tab.
A pointed instrument such as a paper clip will be required to access the Sync
button through the small circular hole.
1. In standby mode press the S-button to cycle through the 6 colour
channels, red / green / blue / yellow / purple / white. (Bright LED =
channel free, Low LED = channel in use) In order to pair an alarm the
channel must be free (see step 2 below otherwise move to step 3).
2. To erase a paired channel, use the S-button to select the channel. Next
press and hold the S-button until the LED changes from low to high
brightness. To quickly erase all channels, Press and hold the S-button
for a longer time until the centre LED flashes multiple colours.
3. When the chosen channel is selected and free, activate the required
alarm head by rotating the roller wheel. The light will illuminate to
indicate that the pairing is complete.
4. Repeat steps 2 and 3 to sync other alarm heads on the light if required.
5. The light will return to normal standby mode once the set delay time
has elapsed.