Sonik GIZMO Bivvy Bedienungsanleitung Seite 3

WELCOME
Congratulations and thank you for purchasing your new Sonik® GIZMO® Bivvy
Light. We are sure that it will provide you with many years of faithful service
in your angling. Please take a few moments to read this manual. The advice it
contains will enable you to get the very best performance from your bivvy light.
GETTING STARTED
BATTERY FITTING/REPLACEMENT
Remove the magnetic and hook back casing by twisting it anti-clockwise.
Unhinge the battery compartment cover clip. Insert carefully 3 x AA 1.5V
batteries noting the polarity shown in the battery compartment. Replace the
battery compartment cover and back case ensuring that it closes positively
into place.
SWITCHING ON / OFF
To turn the light on, press and hold the on/off button for 3 seconds; the LED
indicator will flash red-green-blue and the white LED's will flash three times.
The light is now in standby mode.
To turn the light off, in standby mode, press and hold the on/off button for 3
seconds, the white LED's will flash once.
LED ILLUMINATION
The bivvy light can also be used as a standard light. To turn on/off press the
LED on/off button
VOLUME CONTROL
To adjust volume, press the V button to cycle through the 7 volume levels
available. The lowest volume setting is silent.
BRIGHTNESS CONTROL
In standby mode, press brightness button to cycle through the brightness
settings. There are 4 brightness levels and the centre LED will flash to indicate
chosen level.