Herunterladen Inhalt Inhalt Diese Seite drucken

Faq And Troubleshooting - babymoov Milky Now Benutzungsanleitung

Inhaltsverzeichnis

Werbung

FUNCTION
x 3
3. The water will then cool down naturally. Note that, the hotter your water, the more time it will take to cool down to
the right temperature.
4. Once the temperature has come down, pour the water used to clean your baby bottle water heater down the sink.
5. Use a cotton cloth to wipe away any remaining water.
TIP.You can also use this function instead of function 2
will take longer to cool down naturally.
To ensure your Milky Now baby bottle water heater works effectively, reduce the build-up of scale and ensure the channels are
clean inside the appliance, make sure you clean your appliance once a week (depending on how often you use it) and also if
you do not use your appliance for two consecutive days.
• To thoroughly clean your appliance, follow the recommendations for function 3
• To regularly clean the appliance, use function 3
To clean the outside of the Milky Now:
- always unplug the appliance and ensure the tank is cold.
- clean the outer casing with a soft damp cloth. Leave to dry naturally.
PROBLEMS
Appliance does not heat
"E2" or "E3" appears on
the control panel
** for heating 0.3L of water from 20°C to 37°C
3
• EASILY CLEANING YOUR BABY BOTTLE WATER HEATER
1. Press the MODE
On selecting this function, the water will boil.
2. The water continues to boil for 3 minutes, then stops. You will hear a beep to let you know
that the appliance has finished its cycle.
Once the water is boiling, you can add a few drops of lemon to the tank to make it easier
to clean.
Once the water reaches 100 °C, press the
round the various channels in the appliance.

FAQ AND TROUBLESHOOTING

POSSIBLE CAUSES
∙ Thermostat is not connected.
∙ The temperature set is below that of the actual
water temperature. 
∙ The water level is too low.
MILKY NOW • Instructions for use
button three times to choose the
if you don't like the noise produced by the fan. NOTE: the water
CARE GUIDE
.
function.
button to distribute the boiling water and lemon
.
SOLUTION
∙ Wait for the appliance to cool down then switch it
back on.
∙ Follow the instructions to set the temperature.
∙ Add water.
13

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

A002301Milky now

Inhaltsverzeichnis