HEYLO AC 25 Bedienungsanleitung Seite 23

Auto Swing
• After switching on the machine, you can start the auto swing function by pressing the
"SWING" button.
• Now the air is permanently distributed in the room through the swing flap.
Night mode (SLEEP)
• If the machine is running in cooling mode, first press the SLEEP button to set the temperature. The
temperature then increases by 1°C after one hour and by 2°C after 2 hours.
• If the machine is running in heating mode, press the SLEEP button to set the temperature. The
temperature then drops by 1°C after one hour and by 2°C after 2 hours.
Water tank
The air conditioner has a water level safety switch that controls the water level. When the water level reaches
a certain level, the indicator lights up (FULL). If this happens, remove the rubber plug from the drain at the
bottom of the device and drain all water to the outside.
Continuous dewatering
• If you do not intend to use this device for a longer period of time, remove the rubber plug from
the drain hole at the bottom of the appliance and drain all water to the outside.
• You can use continuous drainage with a drainage hose connected to the bottom drain hole
when the machine is in heating mode.
• Continuous drainage does not need to be connected if the unit is operating in cooling or drying
mode. The unit can automatically evaporate the condensation water. This is done by a pump
which pumps the water to the hot condenser where it can evaporate. Make sure that the
drainage holes are always clean.
• If the water spray motor is damaged, continuous drainage can be used.
(A)
(B)
23
EN