Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b) Operation
Storing the gooseneck
1
•
The rear panel of the housing can be opened by simultaneously pressing on the two "PUSH"
buttons (6) located at the top and bottom. The gooseneck can be handled as needed.
•
Be sure to insert the gooseneck in the opening (10) on the top of the housing before insert-
ing the rear panel.
•
The gooseneck and camera head can be wrapped inside the housing for storage purposes.
Colour monitor
2
•
On the colour monitor, the camera image normally appears in real time. Alternatively, the
saved image / video can be displayed.
•
The status bar will appear on the monitor for a short time when you press a button. The
status bar shows one or more pieces of information.
c) Basic functions
Power ON/OFF
1
•
Press the on/off & snapshot button (5) to switch on the endoscope.
•
To switch off, press and hold down the button (5) for approx. 2-3 seconds.
Rotating the camera image
2
•
The camera image will appear on the monitor. You can press the rotate & delete button (3)
to rotate the image by 180°. Press the button (3) again to rotate the image by 180° again.
Setting illuminance
3
•
There are six LEDs integrated in the camera head. The LED illumination of the camera can
be adjusted in 10 steps.
•
When switched on, the illuminance is set to 60%.
•
Press the down & LED setting button (8) while the camera is in operation. Each press
increases the illuminance by 10%. The luminosity is shown briefly on the display.
26
Werbung
Kapitel
Inhaltsverzeichnis
