Herunterladen Diese Seite drucken

Gebruiksinstructies - Swim & Fun 1932 Bedienungsanleitung

Filterball filter system 90w
Vorschau ausblenden Andere Handbücher für 1932:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 42
NL
6.
Schroef het deksel van de filterkamer handmatig op de bovenkant van de filterpomp.
7.
Sluit de slangen aan als de afbeelding van de installatie laat zien en bevestig de
pomp aan de wand van het zwembad. Vergeet niet om een slangklem te gebruiken.
Draai deze vast met een schroevendraaier.
8.
Laat de filterpompkamer vollopen met water. Laat de filterpomp nooit droog draaien.
9.
Sluit het netsnoer aan op een geaard stopcontact dat wordt beveiligd door
een aardlekschakelaar (GFCI). Neem indien nodig contact op met een gekwalificeerde
elektricien voor verificatiedoeleinden en/of installatie van een GFCI-stopcontact.
Please install your filter pump following the lnstallation illustration bellow.
PLASTIC
CLAMP
OUTLET
OPERATING INSTRUCTIONS
1. The filter pump will prime itself as long as it is positioned at least 20 cm below the highest water
4.
Gebruiksaanwijzing
level is a relief valve located on the top of the pump. Simply turn the valve knob counter-clockwise, and
when a small amount of water escapes, close immediately by turning clockwise.
1.
De filterpomp zal zichzelf vullen zolang hij minstens 20 cm onder het hoogste wa-
The pump will now be completely primed.
terniveau is geplaatst, waar er een ontlastklep op de bovenkant van de pomp zit. Draai
2. Never operate the filter pump dry. This can cause damage to seals which may result in leakage and/
simpelweg de knop van de klep linksom en als er een kleine hoeveelheid water ontsnapt,
or flooding.
3. Prior to each use, check to ensure that all hose-clamps are tightened.
sluit dan onmiddellijk door hem rechtsom te draaien.
4. To prevent possible electric shock, do not attempt to plug in electrical power cord with wet hand or
De pomp is nu volledig gevuld.
while standing in water.
5. The filter pump must operate in the upright, vertical position.
2.
Laat de filterpomp nooit droog draaien. Dit kan schade aan afdichtingen veroorzaken,
6. The filter pump must be positioned on level, table ground. And the use of a riser or elevated platform
wat kan leiden tot lekkage en/of overstromingen.
is not expected.
7. To preserve the full life of the pump and to keep the pool filtered properly, your pump should be run
3.
Controleer voor elk gebruik of alle slangklemmen zijn vastgedraaid.
approximately 4 to 6 hours per day.
8. Overuse may cause overheating and/or motor burnout. Use good judgment on extremely days and be
4.
Om elektrische schokken te voorkomen, mag u het netsnoer niet aansluiten als uw
mindful of running the filter pump continuously for an extended period of time.
handen nat zijn of als u in het water staat.
CLEANING AND REPLACEMENT
5.
De filterpomp moet rechtop, in een verticale positie werken.
1. The Aqualoon in your pump filter system should be replaced approximately once per season.
2. Periodically cleaning of your Aqualoon can enhance the effectiveness of your filter pump and
6.
De filterpomp moet op een vlakke, stabiele ondergrond worden geplaatst.
moderately prolong the Aqualoon's lifespan prior to replacement.
7.
Omwille van een maximale levensduur van de pomp en om het zwembad goed gefil-
3. Keep the power be disconnecting to the unit when changing the Aqualoon.
4. Turn the Air Vale Screw to release the air suction inside.
terd te houden, moet uw pomp ongeveer 4 tot 6 uur per dag draaien.
5. Remove the Filter Chamber Cover and the filter chamber rubber gasket, and then take out the
Aqualoon.
8.
Overmatig gebruik kan oververhitting en/of een verbrande motor veroorzaken.
6. Your clean (or new) Aqualoon can be put back into the filter chamber and you can refer to the
Gebruik uw gezonde verstand op extreme dagen en houd er rekening mee dat u de
installation instruction to re-assemble the filter pump unit.
filterpomp gedurende langere tijd continu laat draaien.
GENERAL MAINTENANCE
1. To avoid dangerous or fatal electrical shock hazard, always disconnect power to the unit before
attempting to clean pump.
52
2. There is no need for any regular mechanical maintenance of the pump unit. (Do not attempt to
disassemble the pump motor at any time).
3. If necessary, clean outside of pump with a mild detergent and water, rinsing off with a hose.
4. There is no need for the use of any lubricants on the pump.
MV-1932-A5-MiniMax filterpump_BOOK.indb 52
MV-1932-A5-MiniMax filterpump_BOOK.indb 52
WATER
DIRECTION
PLASTIC
CLAMP
INLET
MV-1932-4-2020 swim-fun.com © Alle rechten voorbehouden Swim & Fun Scandinavia ApS
LOWER HOSE
CONNECTION
CONNECTING
HOSE
WATER
DIRECTION
UPPER
PROTRUDING
HOSE
CONNECTION
WATER
DIRECTION
09-11-2020 06:37:43
09-11-2020 06:37:43

Werbung

loading