Use Of The Device - CSS AssistX AS one Gebrauchsanweisung

22 | Instructions for Use

8. Use of the device

Connect the device with the enclosed appropriate cable to the
of your CSS product. Place the AS one sensor near the user, if necessary with an
appropriate CSS holder. Because the sensor is magnetic, it adheres to all iron
and steel surfaces. Follow now the steps of 9. Settings.
9. Settings
AS one can learn the frequency that triggers a sensor reaction. The sensor
reacts to noise that comes with defined frequency and volume and that is held
for an adjustable duration. Optional, in impulse mode the sensor reacts to any
noise that reaches an adjustable volume.
Set Impulse Mode & Tone Mode:
Plug the jack cable into the
range button for tone mode or the
and then insert the plug on the other side of the cable on the
or . Press and hold the desired button for 1 sec after inserting it. As
Clickman
soon as the button is released, the
lected mode is active.
LED display
1
Tone Mode:
Default settings preset the device to a frequency of 300Hz +/- 100 Hz and
a hold time of 1 sec. This setting covers the human voice for the most part.
Sensitivity, holdtime and tolerated deviation from the preset frequency, can be
adjusted using the three pushbuttons. Best detection is given for a sounding
„Mmmmm".
AssistX AS one
AssistX AS one
green: Tone Mode (default)
red:
. Then press and hold the
time range button for impulse mode
5
LED lights up red or green and the se-
1
Impulse Mode
AssistX Port
tone
7
device
AssistX