AC Schnitzer 4161 190 3109 Montageanleitung Seite 32

F itt in g In st ru ct io ns
AC Schnitzer Bonnet Vent - Toyota GR Supra
Fitting .... (cont'd.)
Figs. 25 & 26
Draw a second line / later cut line (1) on the bonnet at a
distance of 2.5mm all round from the inner contour of
the AC Schnitzer Bonnet Vent frame previously drawn
(2).
Note !
The cutout must be larger than the inner contour of
the AC Schnitzer Bonnet Vent frame.
Fig. 27
Drill two Ø 3mm holes inside the second line.
Note !
The hole is used to position the air saw or similar !
Do not drill the hole larger than 5mm, to avoid
deformation / bulges in the bonnet !
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
Fitting Instructions No.: 4161 190 3109 / Issue: 29.10.2019 / TSch
2,5mm
32
1
2