Connecting External Appliances; Connect Headphones; Troubleshooting - Telefunken RC1002BM Bedienungsanleitung

9.

CONNECTING EXTERNAL APPLIANCES

„
External appliances, e.g. MP3 players or similar, can be connected via the 3.5 mm
(<?°05 (13) socket.
„
Note: A suitable connection cord is needed (not included).
„
Connect the external appliance to the (<?°05 (13) socket and press repeatedly
FUNCTION (6 or 28) until the indicator
„
When an external appliance is connected, all playback functions will be managed
through the external appliance's controls. The volume control will keep working normally
and can be controlled using Volume control knob (1) or VOL- and VOL+ (37) keys on the
remote control, however all the other playback operation controls will stop functioning as
long as the external appliance is connected.
„
:OV\SK [OL ]VS\TL Z[PSS IL [VV SV^ HKQ\Z[ [OL ]VS\TL VM [OL L_[LYUHS HWWSPHUJL

10. CONNECT HEADPHONES

„
*VUULJ[ OLHKWOVULZ [V [OL OLHKWOVULZ QHJR 
„
Set the volume to a lower level. Listening with too high level might lead to hearing
damage.

11. TROUBLESHOOTING

Problem
Appliance does not
work.
Bad audio quality.
Bad FM reception.
Jumping of tracks
during playback.
Speaker cannot
be connected to
external device via
Bluetooth.
No audio signal
via the Bluetooth
connection.
Bad audio quality.
(IM_for_approval)953-000067_RC1002BM_GB_V03_080115_2010955.indd 33
Possible cause
Power cable (44) is not
connected properly.
Batteries are discharged and/
or not inserted correctly.
Inserted CD is dirty or
scratched.
FM antenna (9) is not pulled
out.
Inserted disc is dirty or
scratched.
Audio source is switched off.
Bluetooth is switched off at the
audio source.
Speaker is not paired to the
audio source.
Volume too low.
Bad Bluetooth reception.
3.5 mm audio cable is not
inserted correctly to external
device.
appears on the display (23).
Solution
Check if the power cable is properly
connected a electrical outlet.
Check if batteries are inserted correctly or
empty.
Clean the disc with a soft cloth or insert
another CD.
Pull out completely and rotate the FM
antenna (9) for best reception.
Clean the disc with a soft cloth or insert
another CD.
Switch on the audio source.
Switch on the Bluetooth function of the audio
source.
Check whether a connection exists. If
necessary, pair the speaker again to the audio
source.
Increase the volume on the device and/or on
the audio source.
Shorten the distance between the Bluetooth
device and the boombox and make sure no
obstacles are disturbing the connection.
Ensure that the connecting 3.5 mm audio
cable is correctly plugged in on both devices
and plugs are fully inserted.
33
EN
1/9/15 8:35 PM