Herth+Buss ELPARTS 95980652 Bedienhinweis Seite 14

Operating Instruction
Stand-by
In operation (30 seconds)
Locked (1 minute)
Stand-by
www.herthundbuss.com
Note:
On vehicles with CAN bus systems and lamp
failure monitoring, the CAN bus button must
be activated before the ignition is switched on
or the lighting is connected. Otherwise this
can lead to an error message from the lamp
failure monitoring in the driver display and the
function of the trailer tester being impaired.
To protect against overload, the load simula-
tors are automatically deactivated after 30
seconds.
After 1 minute, the function is available again.
A time bar in the CAN bus button shows the
user the remaining test time.
The CAN bus button must be activated for fur-
ther testing.
Testing the trailer
5
The test mode and plug type are shown in
the upper section of the screen. To test the
lighting, you can either press each symbol
individually or start a group test by pressing
the button "ALL". The test result is displayed
in green for "OK" or red for "error". Press
"Back" to return to the previous screen.
Attention: The trailer tester is only designed
for functional tests, not for endurance tests.
95980652
14