Cisco 350 Serie Kurzanleitung Seite 6

Repeat
S 3
TEP
connect to the switch.
A category 6a and higher cable is required for 10G ports; a category
N
OTE
5e and higher cable is required for all other ports. When you connect your
network devices, do not exceed the maximum cabling distance of 100
meters (328 feet). It can take up to one minute for the attached devices
or the LAN to be operational after it is connected. This is normal behavior.
Power over Ethernet Considerations
The switch is to be connected only to PoE networks without
W
ARNING
routing to the outside plant.
If your switch is one of the Power over Ethernet (PoE) models, consider the
following power requirement:
350 Switches with Power Over Ethernet
Model
SF350-48P
SF350-48MP
SG350-10P
SG350-10MP
SG355-10P
SG350-28P
SG350-28MP 382 Watts
*60-Watt PoE extends the IEEE Power over Ethernet Plus standard to
double the power per port to 60 watts.
6
Step 1 and Step 2
Power Number of Ports
Dedicated Supporting PoE
to PoE
382 Watts 1—48
*60-Watt PoE: port
1,2,3,4,25,26,27,28
740 Watts 1—48
*60-Watt PoE: ports
1,2,3,4,25,26,27,28
62 Watts 1—8
128 Watts 1—8
62 Watts 1—8
195 Watts 1—24
*60-Watt PoE: ports
1,2,13,14
1—24
*60-Watt PoE: ports
1,2,13,14
Cisco 350 Series and the Cisco 350XG Series Managed Switches
for each device that you want to
PoE Standard
Supported
802.3af/at
60-Watt PoE 802.3af/at,
4-pair PoE
802.3af/at
60-Watt PoE 802.3af/at,
4-pair PoE
802.3af/at
802.3af/at
802.3af/at
802.3af/at
60-Watt PoE 802.3af/at,
4-pair PoE
802.3af/at
60-Watt PoE 802.3af/at,
4-pair PoE