Wall Mounting - Cisco 350 Serie Kurzanleitung

Wall Mounting

Most of the 350 Series Cisco switches include wall-mounting slots on the
bottom of the device. The SG355-10P cannot be wall-mounted.
Insecure mounting may damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure wall
or ceiling mounting.
To mount your switch to a wall:
Determine where you want to mount the device. Verify that the
S 1
TEP
surface is smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface of the wall 94 mm apart.
S 2
TEP
Insert a screw into each hole, leaving a gap between the surface
S 3
TEP
and the base of the screw head.
Place the bottom of the switch over the screws and slide the
S 4
TEP
switch down until the screws fit snugly into the slots.
Connecting Network Devices
3
To connect the switch to the network:
Connect an Ethernet cable to the Ethernet port of a computer,
S 1
TEP
printer, network storage, or other network devices.
Connect the other end of the Ethernet cable to one of the
S 2
TEP
numbered Ethernet ports of the switch.
The Ethernet port light turns green when the connection is active.
Refer to
Features
switch.
Cisco 350 Series and the Cisco 350XG Series Managed Switches
Cisco 350 Series and Cisco 350XG Series Switch
for details about the different ports and LEDs on each
5