Making Ice Cubes - Unold 48955 Bedienungsanleitung

MAKING ICE CUBES

1. Caution: Do not use the first ice cubes that have been produced with the
appliance. Dispose of these ice cubes; they may contain production residues.
2. Prepare the appliance as described in the section "Before using the
appliance the first time".
3. Remove the ice container (4) from the appliance by pulling it forward.
4. Fill the provided measuring cup with
fresh, clean water.
5. Pour the water into the water
tank (see illustration). At least
maximum of 1.8 litres must be
filled into the appliance. Please pay
attention to the respective minimum
and maximum mark on the left side
of the water tank.
6. Do not fill water past the Max marking to prevent water from running out.
7. Slide the ice container back into the appliance.
8. Press the On button to start making ice cubes immediately. If you have
activated the timer, you do not need to press any button; the appliance will
start automatically at the specified time.
9. The appliance starts to make ice cubes. The first ice cubes that are made
do not have the selected size, since it takes several minutes before the
appliance reaches the right operating temperature. Therefore, the first ice
cubes are somewhat smaller.
10. If the pump in the appliance should not transport any water for a longer
period of time, switch off the appliance, and allow a few drops of water to
drip out via the residual drain. Then restart the process.
11. Depending on water and ambient temperature the ice cubes will be ready
in approx. 6 to 18 minutes. Note: At the beginning of ice cube making
process, for technical reasons the ice cubes are still small and of different
sizes.
12. You can interrupt the making of ice cubes any time by pressing the „OFF"
button.
13. If you have programmed the appliance via the timer, you do not need to
press any button, the appliance stops making ice cubes automatically at
the set time.
30
Copyright UNOLD AG | www.unold.de
a