Specifications (Table); Technical Specification - Kontronik DRIVES JIVE Pro Serie Bedienungsanleitung

Our warranty liability shall be limited to repairing or
replacing the unit to our original specifications.
Because we have no control over the installation or
use of these products, in no case shall our liability
exceed the original cost of the product.
All warranty claims terminate with opening of the
product. To accept guarantee the originalbill on
which the product the date of purchase and the
dealer is named must be sent together with the
product.
Also a detailed description of fault is necessary
and should be included:

12. Technical specification

Technical specifications JIVE Pro
Connections:, 2 x BEC cable, 1 x Sensor cable, 2 x battery cable, 3 x motor cable
BEC voltage
BEC permanent current
BEC max. current (temporary)
Shut down / switch off voltage, LiPo
Shut down / switch off voltage, LiFePo
Shut down / switch off voltage, NiCd, NimH
Switch off when under voltage
Spool up time in Heli mode
automatically clock frequency
Permanent current motor JIVE Pro +80HV
Permanent current motor JIVE Pro +120HV
Voltage range
Number of cells (LiPo)
Measurements JIVE Pro 80+ HV length x width x height
Measurements JIVE Pro 120+ HV length x width x height
Weight, without / with cables JIVE Pro +80HV
Weight, without / with cables JIVE Pro +120HV
Safety time after Bail out
Switch off when no receiver signal
www.modellmarkt24.ch www.modellmarkt24.ch
24
· used motor,
· propeller diameter
· number and type of batteries
· time of failure
Please use the KONTRONIK service form for
sending in to:
KONTRONIK GmbH
- Servicecenter -
Etzwiesenstrasse 35/1
D-72108 Rottenburg
Do not forget to write your address on the
package, in capital letters!
Default
5.6 V
8.0 A
20.0 A
3.0 V
2.3 V
0.8 V
approx. 60 s
12 s
32 kHz or higher
80 A (when sufficient cooled)
120 A (when sufficient cooled)
16-50 V
5 – 12
2.44 x 1.26 x 0.67 inch
2.44 x 1.26 x 0.83 inch
2,26 / 3,32 oz (64 / 94 g)
3,03 / 4,51 oz (86 / 128 g)
90 s
after approx. 2 s
adjustable (programming unit)
5 – 8 V
2.7 – 3.5 V (0.1 V-steps)
1.8 – 2.6 V (0.1 V-steps)
0.7 – 1.2 V (0.1 V-steps)
8 – 60 s
1 – 4 s