Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3-PIN TO 5-PIN CONVERSION CHART
Note! If you use a controller with a 5-pin DMX output connector, you will need to use a 5-pin to 3-pin adapter.
The chart below details a proper cable conversion:
3 PIN TO 5 PIN CONVERSION CHART
Conductor
3 Pin Female (output)
Ground/Shield
Pin 1
Data (-) signal
Pin 2
Data (+) signal
Pin 3
Do not use
Do not use
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connecter side of the DMX cable to the output (female) 3 pin connecter of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connecter to the input
connecter of the next fixture consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as
stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initialized
for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also
require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete instructions
for this type of setup and configuration.
Navigation through the Control Panel
Access control panel functions using the four panel buttons located directly
underneath the LCD Display.
Button
Function
<MODE/ESC>
Used to access the menu or to return to a previous menu option
<UP>
Scrolls through menu options in ascending order
<DOWN>
Scrolls through menu options in descending order
<ENTER>
Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected menu
function. To select a menu item, press <ENTER>.
Digital Display Operation
A001~A511
8CH DMX Mode ,Jump flash ( Already connect DMX)
SLAU
Slave Mode
CF01~CF99
Gradual Change ,(1-99 color change speed from slow to fast)
CJ01~CJ99
Jump Change ,(1-99 color change speed from slow to fast)
CP01~CP99
Pulse Change ,(1-99 color change speed from slow to fast)
©Copyright LOTRONIC 2015
5 Pin Male (Input)
Pin1
Pin 2
Pin 3
Do not use
Do not use
LEDPAR-LAS
Page 4
Werbung
Inhaltsverzeichnis
