Before Installation; Safety Instructions For Installation; Safety Instructions For Commissioning - schellenberg DRIVE Action 60920 Bedienungsanleitung

BEFORE INSTALLATION

The garage door drive is not designed for operation of stiff doors.
Check that the door can be opened and closed easily by hand�
Check that the compensation springs have been set correctly by lifting the door approx� one metre and then
letting it go� The door may not move upwards or downwards from this position�
The compensation springs on the garage door may only be readjusted by a competent person�
The garage ceiling must be suitable for installation of the garage door drive� Check whether additional fastening
components are required�

SAFETY INSTRUCTIONS FOR INSTALLATION

During installation work, all applicable provisions for occupational safety and all applicable provisions for
operating electrical devices must be followed� The required national guidelines must also be observed�
Follow the instructions and information in this installation manual� If you are ever unsure during installation,
contact our customer service (see back page).
Potential hazards within the meaning of DIN EN 13241-1 can be eliminated by installing the product as per this
instruction manual�
Electrical connection work may only be carried out by a trained electrician�
The garage door should be balanced. Immovable or stiff doors must be repaired. When unbalanced, garage
doors, door springs, cables, pulleys, supports and rails are placed under extreme stress, which can result in
serious injuries� Try not to detach, move or realign the door� Seek out a suitable trained technician�
For garages without additional access, an emergency release for the rotary handle (item no. 60553) or an
emergency release lock (item no. 60511/60513) is required. These devices prevent you from being locked out
of the garage in the event of a defect or power cut�
Before fitting the garage door drive, remove any existing locks and locking devices as per the assembly
instructions for the garage door in order to ensure unencumbered use of the garage door drive�
Install all optional operating elements (e.g. key switch (item no. 25101/25103, 25102/25104) or wall button (item
no. 60060/60061)) at a height of at least 1.5 m and within sight of the garage door, but away from moving parts
and out of the reach of children�
Affix the anti-pinching warning labels in a clearly visible location or near the switch.
Affix the manual release sticker near the garage door drive.
Before commissioning your garage door drive, ensure that there are no obstacles in the travel path of the door.
Read the instructions carefully�
During installation, adhere to the minimum distances shown in the figures.
Drilling dust, dirt or shavings must not enter the garage door drive head or rail system� Cover these components
carefully during installation work�

SAFETY INSTRUCTIONS FOR COMMISSIONING

Check your power connection� The values must match the values given in this operating manual�
This information is also found on the nameplate of the garage door drive�
The power connection in the garage must comply with local provisions�
Check the safety functions of the garage door drive as follows:
Place an object (e.g. a piece of wood) measuring approx. 50 mm in height under the main closing edge of the
garage door� Allow the door to lower� When the door comes into contact with the obstacle, the garage door drive
must reverse and give way to the object�
For extra safety, use an optional light barrier (item no. 60030/60031) and check the automatic safety reversing
function at regular intervals�
After the test run, the safety device (obstacle detection system with force reversal, light barrier) must be checked.
The commissioning of the end product or combination by Alfred Schellenberg GmbH is prohibited until
conformity of the end product or combination of garage door drive and garage door has been proven based on
the applicable standards, specifications and/or guidelines. In case of doubt, a specialist installation company
should be engaged�
13
GB