Blade And Cooling System - Scantool 220 GSHT Gebrauchsanweisung

2. The saw blade ( A ) should also ride between and lightly touch the two blade guide
roller bearings ( E ) and ( F ) ( fig 9 ) The front bearing ( E ) (fir ) ) is mounted on an
eccentric, and can easily be adjusted suit blade thickness by loosening set screw (
G ) and turning shaft ( E ).
3. The carbide blade guides ( H ) ( fig. ) ) should also be adjusted so they lightly touch
the blade by loosening screw ( K ).
4. The blade guide roller bearings, carbide guides and backup bearing on holder ( fig
9 ) should be adjusted in the same manner.
5. Cutting chips on the blade will be cleared by the steel brush.

8.7 BLADE AND COOLING SYSTEM

The use proper cutting fluid is essential to obtain
maximum efficiency from a band saw blade. The main
cause of tooth failure is excessive heat build-up. This is
the reason that cutting fluid is necessary for long blade
life and high cutting rates. Cutting area and blade wheels
should be kept clean at all time.
The rate of coolant flow is controlled by the stop valve
lever ( A )(fig.4 ), which directs the coolant onto the
blade. The lever ( A ) is shown in the off position.
ALWAYS KEEP THE FLOOR DRY TO PREVENT SLIP OR ANY ACCIDENT.
8.8 OPERATING THE TRU-LLOCK VISE SYSTEM INSTRUCTIONS
To operate proceed as follows:
1. Raise the 2" above the work piece.
2. Put your work piece on the table. Move the
vise handle ( A ) upwards to an angle of 45
degree ( a-half opened) to loosen the vise.
Move the vise jaw bracket against the work
piece by turning the rectangular handle ( B ).
Push down on the vise handle ( A ) to lock
the work piece in position.
3. To loosen the work piece from the vise, hold
the work piece and lift the vise handle ( A ) to
a 90 degree position ( completely opened ).
Remove work piece.
CONTINUED CUTTING:
When you need to cut a work piece many times, just raise the vise handle ( A ) down first,
and the tightening the vise by turning the rectangular handle ( B ) clockwise. After finishing
the cut, you can loosen the work piece by turning rectangular handle only. This Tru-Lock
Vise System has a 4 mm tightening travel when the rectangular handle is completely
Scantool 220 GSHT
40