Cleaig & Luricating; Minimum Room Space For Machine Operation - Scantool 220 GSHT Gebrauchsanweisung

2 Hang the machine up, away from the floor, take away the 4 pads and
assemble them on the auxiliary stand. Fix the machine on the auxiliary
stand and lock the connection nut.
3 Finish removing this wooden case/crate from the machine. Unbolt the
machine from the crate bottom.
4 Position & tighten 4 bolts into base holes properly after machine in
balance.
5 Turn off the power before wiring & be sure machine is in proper grounding.
Overload & circuit breaker is recommended for safety wiring.
6 Keep machine always out from sun, dust, wet, raining area.
4.4 CLEAIG & LURICATING
1. Your machine has been coated with a heavy grease to protect it in shipping.
This coating should be completely removed before operating the machine.
Commerial degreaser, kerosene or similar solvent may be used to remove
the grease from the machine, but avoid getting solvent on belts or other
rubber pars.
2. After cleaning, coat all bright work with a light lubricate all points, with a
medium consistency machine oil.

5. MINIMUM ROOM SPACE FOR MACHINE OPERATION

Scantool 220 GSHT
34