Telltale Chips; Use Of Main Machine Parts; Power Systems And Control Panel - Scantool 220 GSHT Gebrauchsanweisung

TELLTALE CHIPS

Chips are the best indicator of correct feed force. Monitor chip information and adjust feed
accordingly.
Thin or powdered chips – increase feed rate or reduce
band speed.
Burned heavy chips – reduce feed rate and/or band speed.
Curly silvery and warm chips – optimum feed rate and
band speed.

8. USE OF MAIN MACHINE PARTS

8.1 POWER SYSTEMS AND CONTROL PANEL

The electrical rating of your band saw is either with 230 volt-
single phase, or 400 volt-3 phase, magnetic control.
Before connecting your machine to an electrical power system,
be sure the motor shaft is running in the correct direction.
We recommend that 1,5mm
element, time lag fuse, to be used to supply power to all
machines regardless of their electrical rating.
Refer to the electrical wiring diagram supplied with your
machine for instructions on how to connect saw to power
source. Power must be cut off when wheel cover is opened or
dring repairing.
Please check the moving direction of the blade. If the blade is moving in the wrong
direction, please re-connect the wire.
8.2 STARTING AND STOPPING MACHINE
1. light (D) will be on when power is connected.
2. Start the motor by turning the start button ( C ), Push
the button ( E ) to start blade saw. Unhand button ( E )
stop the motor.
3. Turn ( A ) ( 0-close, 1-open ) to open the coolant
system
4. When saw blade is closing work piece. Or when the
cut is completed, turn off the coolant system ( A )
5. Press emergency button ( B ) to shut-off the motor
when in emergent situation.
2
fused with a 10 amp, dual
Scantool 220 GSHT
38