Connecting The Amplifier - Zeck Audio TWISTER 12.6 P Bedienungsanleitung

C without tube stands
This setup variation requires two TWK 10 SP/KLK and two TWK 10 KLK adaptor
cables (available as an accessory).
1. Place all satellites and subwoofers in suitable positions. Bear in mind that you can
attenuate the output of the TW 6 TOP M satellites by 6 dB. If required, use the
beveled satellite edges to tilt them upwards to aim at the user.
2. Use the TWK 10 SP/KLK adaptor cables to connect the TW 6 TOP M satellites with
their assigned subwoofers. The 1/4" line connectors of the cables go to the plugs of
the monitors, which are located at the bottom of their tube stand socket. The
Speakon plugs of the cables go into the 'OUT' connector on the subwoofer
connector panels.
3. Use the TWK 10 KLK adaptor cables to connect the TW 6 TOP M satellites with the
TW 6 TOP satellites. The 1/4" line connectors of the cables go to the plugs of the
satellites which are located at the bottom of their tube stand socket.
Connecting TWISTER 12.6 P system to
power amplifier
Use the Speakon socket 'IN' on the sub-
woofer connector panel to connect the
TWISTER speaker system with the ampifier.
See page 18 ('Subwoofer connector panel')
for the required contact configuration of the
Speakon plugs on the TWISTER side.
The amplifier side of the cables must be
equipped according to the amplifier used.
Connection of TWISTERMIX Ü page 22
Connection of TWISTERAMP Ü page 22.
Twister PA systen owner's manual © Zeck Audio 2000
Downloaded from www.Manualslib.com

Connecting the amplifier

manuals search engine
MONITOR
- 6dB
IN OUT
2-pole Speakon
from
power
amplifier
21