Attenuator switch for TW 6 TOP M
Use this button to attenuate the
level of the TW6TOPM satellite by
6 dB. Lowering the level of this satel-
lite can be useful when it is used as a
monitor.
Use this Speakon input to connect your TWISTER
system to an amplifier or power mixer.
Required wiring for Speakon plug (seen from
terminal side of Speakon plug):
Ground
2+
2-
TWISTER 12.6 P
TWISTERMIX
Connecting and disconnecting
The cabinets of the Twister system are
equipped with four-pole Speakon connec-
tors. These connectors have a locking mech-
anism that protects the cables from being
pulled by accident. After insertion (1.), the
plugs have to be turned counterclockwise a
quarter turn (2.) until they snap into locking
contact postion.
When unplugging the cabel, first pull back
the locking latch (1.). While holding the latch,
turn the whole plug counterclockwise (2.)
and pull it out of the socket (3.).
18
Downloaded from
www.Manualslib.com
Subwoofer connector panel
Input connector
Ground
Signal
Satellites
1-
2+
1+
2-
Ground
TWISTERAMP
Speakon connectors
manuals search engine
MONITOR
- 6dB
This Speakon output allows to connect
the TW 6 TOP M satellite cabinet via a
Subwoofer
TWK 10 SP/KL adaptor cable (available as
1-
an accessory) when it is used as a floor
1+
monitor.
Connecting
Disconnecting
IN
OUT
Monitor output
2.
1.
2.
3.
1.