Atag Cube Installationsanleitung Seite 7

programmed operation
Programmed operation is controlled by
the heating/cooling schedule set on a
device capable of setting schedules.
Press the "MODE" button until the display
shows " " (Fig. 7).
Timed adjustment
room temperature
In programmed mode, you can temporar-
ily modify the set-point temperature set
on a device capable of setting schedule.
Press the temperature adjustment keys
+ -
" " and " " to set the room temperature
(Fig. 8).
Press "OK" to confirm the temporary set-
ting.
The display will now show "
time for which the changed setting ap-
plies will flash (3h default) (Fig. 9).
Press "+" and "-" to set the duration of the
modification, which can vary between 0
hour (minimum) and 24 hours (maximum).
Press "OK" to confirm the modified set-
ting.
The display will now show the detected
room temperature again.
When the temporary setting times out,
the display will again show the set-point
temperature set with a device capable of
setting schedule.
To cancel the modified setting, press
"MODE" and select manual mode.
Press the "MODE" button until the display
shows " " to return to programmed
operation.
Fig. 7
" and the
Fig. 8
Fig. 9
GB - 7