Reely SKYLAND 2201305 Wichtiger Hinweis Seite 2

Important note
SKYLAND Model Airplane RtF
Item no. 2201305
Dear customer,
Unfortunately, two errors have crept into the operating instructions.
The corrections are listed below.
Thank you for your kind attention.
Your Reely team
Sections in the manual
11.3 and 11.4
11.5.4
11.3 Connect flight battery and pair remote control/receiver
B1 B2
Important! When the flight battery is connected, the automatic controls may start the
model unexpectedly. Keep body parts and objects away from the propellers!
11.3.1 Connect battery
1. If switched on, switch the remote control off with the on/off switch (R2).
2. Turn over the model.
3. Open the battery compartment cover.
4. Connect the battery to the power supply cable
5. Carefully slide the battery into the battery compartment
replaced by section in this document
11.3
11.4.4
B1 .
B2 .
6. Close the battery compartment cover. Make sure it locks.
7. Place the model on the landing gear and let it rest for at least 3 seconds to let the electronics complete
the self-test.
11.3.2 Pair remote control and receiver
1. Move the left-hand joystick (R14) for the motor function to the lowest position.
2. Make sure that the right-hand joystick (R4) is in the central position.
3. Switch on the remote control via the on/off switch (R2). Pairing starts after you hear a beep sound. Pay
attention to the indicator light on the remote control.
- Blinking: pairing in progress
- Solid: successfully paired
4. (If pairing failed) Switch the remote control off and repeat the pairing procedure.
11.4 Check the control functions
11.4.4 Rudder
C3 C4
1. Unlock the motor via the motor lock button
2. Move the right-hand joystick to the right
- The rudder should turn right.
3. Move the right-hand joystick to the left
C4
- The rudder should turn left.
4. Lock the motor with the motor lock button .
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE.
(R11).
C3 .
.
*2201305_v1_1020_02_jh_hs_(2)