Environmental Protection; Maintenance - Kress KUX15P Originalbetriebsanleitung

For drilling of
concrete or masonry
For chiseling.
Chisel rotation
position for
adjustment of the
chiseling position.
(Non-work position)
WARNING: The operating mode selector
switch may be actuated only at a
standstill.
7. Replacing carbon brush (See Fig. D)
8
Check if the carbon brush is worn out when the machine
has an unstable speed or the machine fails to operate
EN
after turning on.
When this happens, please replace the carbon brush as
follows:
1) Unplug the power cord.
2) Open the carbon brush cover (e) with a screwdriver
(not supplied).
3) Replace the two carbon brushes at the same time.
8. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve
the load on the machine immediately and allow cooling
for approx. 30 seconds at the highest no-load speed.

MAINTENANCE

Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your
power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice.
PLUG
REPLACEMENT(ONLY
FOR REWIRABLE PLUG
OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
BLUE =NEUTRAL
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug, proceed
as follows. The wire which is colored blue must be
connected to the terminal which is marked with N. The
wire which is colored brown must be connected to the
terminal which is marked with L.
Warning!
Never connect live or neutral wires to the earth terminal
of the plug. Only fit an approved 13ABS1363/A plug and
the correct rated fuse.
Note: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed
cable, it must be destroyed to prevent engaging into a
socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
BROWN = LIVE
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip