Balluff BVS003P Betriebsanleitung Seite 50

BVS SL-_1280Z00-07-000
SMARTCAMERA Lite
3.5.1 Power I/O
5-pin M12 plug, A-coded
Pin Signal
1
2
3
4
5
6
7
8
9
10
11
12
These I/O signals can be used to control the camera or transfer individual information to the host system. As a result, the
image acquisition can be triggered via these I/O signals. Outputting a binary analysis result is also possible. The assign-
ment of the I/O signals is done via the BVS Cockpit interface (see "Digital I/O interface").
3.5.2 Characteristics of the I/Os
•
SPSIO0 - SPSIO5 are digital in-/outputs. Each of them could be used as an input, output, trigger line or for control-
ling flash lights.
•
The inputs switch at approx. 11.3 V (supply voltage > 18 V; i.e. PLC).
•
The inputs switch at approx. 50 % of the supply voltage (supply voltage <= 18 V).
•
Max. output current for each output is 200 mA.
•
Current limited output (< 450 mA)
•
5 μs input filter for spike suppression
•
Reverse polarity protection
•
Overtemperature protection
16
Function
+24 V Supply voltage
DC
GND Ground
RS232RX Input RS232 TxData standard
level
RS232TX Output R232 RxData standard
level
I/O1 Input/output
I/O GND Can be connected to GND.
I/O0 Input/output
I/O2 Input/output
I/O3 Input/output
I/O4 Input/output
I/O5 Input/output
NC Not connected
Level and power consumption / output
current
360 mA / 12 V or 180 mA / 24 V
-3 V to -15 V / +3 V to 15 V
-3 V to -15 V / +3 V to 15 V
Max. output current 200 mA / short circuit
proof
Max. output current 200 mA / short circuit
proof
Max. output current 200 mA / short circuit
proof
Max. output current 200 mA / short circuit
proof
Max. output current 200 mA / short circuit
proof
Max. output current 200 mA / short circuit
proof
Pin may not be used.