Herunterladen Inhalt Inhalt Diese Seite drucken

Function Menu; Function Mode - IBIZA LIGHT 9BEAM-MINI Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

connect a DMX signal terminator.
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

FUNCTION MENU

ADDR A001-A512 001 - 512, DMX Address setting
16CH
CHND
24CH
select the channel mode
48CH
MAST
Master AUTO mode
Soun
Master Sound control mode
SLND
SL1
DMX control mode
SL2
Slave mode
SH0
Effect 0 (recommend)
SH1
Effect 1
SHND
SH2
Effect 2
SH3
Effect 3
SENS
0-99
Sound sensitivity control (0 close, 100 The most sensitive)
bLAc
OFF if no DMX signal is present
Auto
Auto running if no DMX signal is present
bLnd
Soun
Sound control if no DMX signal is present
HoLd
Keeps last DMX control state if no DMX signal is present
Red
0-255 White balance adjust
Green
0-255 White balance adjust
Wile
Blue
0-255 White balance adjust
White
0-255 White balance adjust
No
X motor forward moving
rPAN
YES
X motor reverse moving
No
Y3 motor forward moving
rTiL
YES
Y3 motor reverse moving
YES
REST
Reset

Function Mode

DMX address setting
1. Press the the MENU button until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. When you have found your desired DMX address press ENTER then press and hold the MENU button for at
least 3 seconds to store your desired DMX address.
3. Connect your DMX Controller.
CHnd - This will let select your desired DMX channel mode.
1. Press the MENU button until "CHnd" is displayed, press ENTER. Either "16CH", "24CH", "48CH" will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm and exit.
©Copyright LOTRONIC 2016
9BEAM-MINI
Page 4

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

15-1432

Inhaltsverzeichnis