cecotec ForceTitanium 650 Bedienungsanleitung Seite 18

ENGLISH
for advise, repairs, or returns.
· Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
· Place the appliance on an even, heat-resistant surface. Do not place the appliance near heat
sources, places with high humidity levels, or combustible materials.
· Plug the appliance into an appropriate wall outlet. The plug must be accessible so that, in
case of an emergency, it can be easily unplugged.
NOTE: you may notice a slight burning smell or smoke when using the appliance for the
first time, caused by the excess of lubricants from the manufacturing process. Ensure
good ventilation and let the appliance work until no odour or smoke can be noticed.
How to fill with water:
Make sure the iron is turned off and unplugged from the mains supply before following the
instructions below:
1. Turn the steam dial to position '0' before filling the tank with water.
2. Open the cap of the tank and fill it up to the 'MAX' mark on the tank. The water level can be
seen through the transparent side of the tank when the iron is placed upright.
3. Pour out the remaining water after use.
Note: tap water can be used in this iron. Do not use water additives or substitute water,
such as linen or scented water in the steam iron. They can stain fabrics or damage the
iron. Do not exceed the 'MAX' mark on the tank.
4. OPERATION
Preparation
Sort the laundry according to the international symbols on the label of the different pieces of
clothing or the type of fabric.
Label
18 FORCETITANIUM 650
05106_ForceTitanium 650_Manual_DS.indd 18
Fabric type
Synthetic
Silk - Wool
Cotton - Linen
Not to be ironed
Thermostat regulation
·
Low temperature
··
Medium temperature
···
High temperature
21/12/18 8:54