Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PAK-312M/SW
Order number 25.7170
ELECTRONICS FOR SPECIALISTS
ELECTRONICS FOR SPECIALISTS
PA Speaker System
with 370 W Amplifier
Please read these operating instructions care-
fully prior to operating the unit and keep
them for later use�
1 Applications
The speaker system PAK-312M/SW is suited for
numerous PA applications and can be used in
fixed installations and for mobile applications� It
is possible to use the speaker system as a floor
monitor or to place it on a speaker stand using
the stand sleeve�
The speaker system is designed as a 12/2 full-
range bass reflex system and is equipped with a
30 cm bass speaker (12") and a coaxial 25 mm
horn tweeter (1")� A digital amplifier (class D,
300 W
) is used for bass frequencies, and an
rms
analog amplifier (class A /B, 70 W
high frequencies� The audio signals pass a digital
signal processor (DSP) including a signal limiter�
2 Safety Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains volt-
age� Leave servicing to skilled per-
sonnel only! Inexpert handling may
result in electric shock�
•
The unit is suitable for indoor use only� Protect
it against dripping water and splash water, high
air humidity and heat (admissible ambient tem-
perature range: 0 – 40 °C)�
•
Do not place any vessel with liquid on the unit,
e� g� a drinking glass�
•
Immediately disconnect the mains plug from the
socket
1� if the unit or the mains cable is visibly
damaged,
2� if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3� if malfunctions occur�
In any case the unit must be repaired by skilled
personnel�
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug�
•
For cleaning only use a dry, soft cloth; never use
water or chemicals�
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, or if it is
not repaired in an expert way�
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment�
ELECTRONICS FOR SPECIALISTS
PAK-312M/SW
ACTIVE DSP
SPEAKER SYSTEM
) is used for
rms
ZUM FALSCH 36
28307 BREMEN
GERMANY
3 Connections and Control Elements
Prior to connecting or changing connections,
�
always switch off the speaker system and the
units to be connected!
1 Input signal switch to switch between micro-
phone level and line level for input A
2 Switch for sound adjustment
MUSIC
FLAT
LOWCUT = filter for suppressing low frequencies
3 LED indicators
ON = power indicator
SIG = signal indicator
CLIP = overload indicator
4 Volume control MASTER
CAUTION Never adjust a very high volume� Per-
seem to be that high any more after some
time� Therefore, do not further increase a high
volume after getting used to it�
5 POWER switch
6 Inputs (XLR /6�3 mm jack, bal�) to connect units
with line outputs (mixer, MP3/CD player, etc�)
When the input signal switch (1) has been set to
the position MIC, a microphone can be connected
to the upper jack A�
7 Feed-through outputs
At these outputs, the signals of the corresponding
input jack (6) are available so that they can be sent
to another active speaker system, for example�
8 Output jack MIX OUT
At this jack, the mixed signal of the two input
jacks (6) is available; the level depends on the
position of the control MASTER (4)�
9 Support for the mains fuse
Always replace a blown fuse by one of the same
type�
10 Mains jack for connection to a mains sock-
et (230 V~/50 Hz) by means of the mains cable
supplied
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
Copyright
by MONACOR INTERNATIONAL. All rights reserved.
©
ELECTRONICS FOR SPECIALISTS
ELECTRONICS FOR SPECIALISTS
1
2
LINE
MIC
MUSIC
FLAT
LOW CUT
MIC/ LINE IN A
LINE OUT A
LINE IN B
LINE OUT B
6
7
= music reproduction
= no sound modification
(≤ 120 Hz) activated
manent high volumes may damage
your hearing! Your ear will get accus-
tomed to high volumes which do not
ELECTRONICS FOR SPECIALISTS
3
4
5
POWER
ON
SIG
CLIP
MASTER
230V~/ 50 Hz /510 VA
0 dB
USE ONLY WITH A 250V FUSE
T5AL
MIX OUT
WWW.IMGSTAGELINE.COM
8
4 Specifications
Amplifier power
bass: � � � � � � � � � 300 W
treble: � � � � � � � � 70 W
Frequency range: � � � � � 50 – 20 000 Hz
Inputs
sensitivity: � � � � � � 500 mV (LINE),
input A can be
switched to 7 mV (MIC)
impedance: � � � � � 30 kΩ (LINE) / 1 kΩ (MIC)
connection: � � � � � combined XLR /6�3 mm
jack, balanced
Max� SPL: � � � � � � � � � � � 122 dB
High pass filter (low cut): 120 Hz, 24 dB/octave
Power supply: � � � � � � � � 230 V~/50 Hz
Power consumption: � � � 510 VA max�
Ambient temperature: � 0 – 40° C
Dimensions: � � � � � � � � � 480 × 380 × 500 mm
Weight: � � � � � � � � � � � � 19 kg
Subject to technical modification�
A-1669.99.01.06.2015
ELECTRONICS
9
10
rms
rms
Werbung
