Balluff BES Q08ZC-YPL20B-BP00,3-GS04 Anleitung Seite 2

BES Q08ZC-YPL20B-BP00,3-GS04
Inductive Sensors
The CE Mark verifies that our products meet
the requirements of the current EU Directive.
Intended use
The inductive switching sensor
BES Q08ZC-YPL20B-BP00,3-GS04 is intended for
communication with a machine controller (e.g. PLC) or for
connection to an IO-Link master. It is intended to be
installed into a machine or system and used in the
industrial sector. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original Balluff accessories. Use of any other
components will void the warranty.
Non-approved use is not permitted and will result in the
loss of warranty and liability claims against the
manufacturer.
Downloading further instructions
A detailed user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
General safety notes
Installation and startup may only be performed by
qualified personnel with basic electrical knowledge.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the sensor will not result in hazards to persons or
equipment. If defects and unresolvable faults occur in the
sensor, take it out of service and secure against
unauthorized use.
For use only in the secondary of a Class 2 source of
supply. À utiliser uniquement sur le côté secondaire d'une
source de tension de classe 2.
Dimensions and function
If metal is present at a defined distance from the active
surface, the sensor outputs a switching signal (only in the
medium air).
LED
Yellow
Active surface
Order code
5
40
10 20
www.balluff.com
Function
Function indicator
4
Cable length
2×M3 LED
Electrical connection
M12 plug Pin
1
2
3
4
Installation
The general installation instructions for inductive
sensors can be found at www.balluff.com.
Distances:
1)
1)
f
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F.
Germany
Phone +49 7158 173-0
Fax +49 7158 5010
balluff@balluff.de
Description
+
DO
–
C/Q
1) active
surface
a ≥ 3 × d
b ferromagne-
tic materials:
0 mm
non-ferrous
metal: 0 mm
c ≥ 2 × d
d 8 mm
f ≥ 3 × Sn
english 1