Roto ZEL STG ZSU 24V Bedienungsanleitung Seite 40

Connection as a drive controller
Caution
• Risk of injury by electric shock.
• Terminal connections must be carried out by an authorised electri-
cian!
• If more than one drive is controlled using the timer 24 V (TC52), the
drives must be decoupled by relay controls. This decoupling is not
applicable to Roto drives with electronic limit stop.
Always observe the switched current of the device.
1..Connect.the.power.supply.unit.to.the.timer.24.V.(TC52).as.follows:
2..Put.the.protective.caps.back.on.the.power.supply.unit.
3..Fix.the.power.supply.unit.in.the.box.
4..Put.the.operating.device.in.the.frame.and.plug.it.into.the.power.supply.unit.
40 Englisch