TFA 30.3055 Joker Bedienungsanleitung Seite 8

TFA_No. 30.3055_Anleitung
JOKER - Wireless thermometer
D: Outdoor transmitter (Fig. 3):
Display:
D 1: Channel number
D 2: Temperature
Housing:
D 3: Wall mounting hole
D 4: Battery compartment
6. Getting started
6.1 Insert batteries
• Place both instruments on a desk with a distance of
approximately 1.5 meter. Avoid getting close to possible
interference sources (Electronic devices and radio installa-
tions).
• Open the battery compartment of the transmitter by
pressing the notch with your thumb and then lift the
cover.
• Insert two new batteries 1,5 V AAA polarity as illustrated.
• Close the battery compartment again.
• Open the battery compartment of the basic station and
insert two new batteries 1.5 V AAA, polarity as illustrated.
• All LCD segments will be displayed for about a few se-
conds.
• Close the battery compartment again.
6.2 Reception of outdoor temperature
• After the batteries are inserted the outdoor temperature
will be transmitted automatically to the basic station.
• The reception symbol appears on the upper display. The
basic station will scan the outdoor temperature.
• If the reception of the outdoor temperature fails, "- -"
appears on the display. Check the batteries and try it
again. Check if there is any source of interference.
• You can start the initialization manually. Hold the
ton on the basic station for three seconds.
6.3 Display
• The upper display shows the outdoor temperature.
• The lower display shows the indoor temperature.
14
12.02.2015 14:50 Uhr
but-
Seite 8
JOKER - Wireless thermometer
6.4 Store and reset maximum and minimum values
• As soon as the basic station and the outdoor transmitter
are active the maximum and minimum values for indoor
and outdoor will be stored.
• Press and hold the
or minimum values will be reset to the actual values.
• During a manual transmitter search all maximum and
minimum outdoor values will be also reset to the current
values.
6.5 Backlight
• Press the button or the
light for few seconds.
7. Positioning and fixing of the basic station and the
outdoor transmitter
• With the foldable leg at the back of the basic station, the
basic station can be placed onto any flat surface or wall
mounted at the respective location by the hanging hole
at the back of the basic station. Avoid the vicinity of any
interfering field like computer monitors or TV sets and
solid metal objects.
• With the hanging hole at the back of the outdoor trans-
mitter, the outdoor transmitter can be wall mounted at
the respective location. Choose a shady and dry position
for the outdoor transmitter. (Direct sunshine falsifies the
measurement and continuous humidity strains the elec-
tronic components needlessly).
• Check the transmission of the signal from the outdoor
transmitter to the basic station (transmission range of up
to 100 m free field). Within ferro-concrete rooms (base-
ments, superstructures), the received signal is naturally
weakened.
• If necessary choose another position for the outdoor
transmitter and/or basic station.
8. Care and maintenance
• Clean the devices with a soft damp cloth. Do not use sol-
vents or scouring agents.
button and the recorded maximum
button to activate the back-
15