Hama 00178336 Bedienungsanleitung Seite 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized
with a dangerous voltage of su cient magnitude
to constitute a risk of electric shock.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to speci c hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• Charger (USB-A), QC 3.0, 2.0
• USB-A – Micro USB charging cable
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits given in the speci cations.
• Do not modify the device in any way. Doing so
voids the warranty.
• Do not continue to operate the device if it
becomes visibly damaged.
• Use the product for its intended purpose only.
• Keep this product, as all electrical products, out of
the reach of children!
• Do not use the product in the immediate vicinity
of heaters or other heat sources or in direct
sunlight.
• Lay all cables so that they do not pose a tripping
hazard.
• Do not bend or crush the cable.
• Always pull directly on the plug when
disconnecting the cable, never on the cable itself.
• Dispose of packaging material immediately
according to locally applicable regulations.
• The product is intended for indoor use only.
• Use the item only in moderate climatic conditions.
2
• Do not use the product in areas where the use of
electronic devices is not permitted.
• Do not use the product in moist environments and
avoid splashes.
Risk of electric shock
• Do not open the device or continue to operate
it if it becomes damaged.
• Do not use the product if the AC adapter,
adapter cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
quali ed experts.
4. Operation
Note – Mains voltage 100 – 240 V
The charger is suitable for a mains voltage of
100-240 V and can be used around the world.
Please note that a country-speci c adapter may
be necessary.
Warning – Connecting terminal
devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply su cient power for the device.
• Ensure that the power of the connected
terminal device does not exceed 18 W.
• Please refer to the instructions in the operating
manual of your terminal device.
Note – QC 3.0, 2.0
• Plug & go: No manual setup necessary, just
connect and start:
Voltage and power are automatically
con gured by QC 3.0, 2.0.
• For e cient and optimised charging, the QC
3.0, 2.0 function must be supported by your
terminal device.
• With the large quantity of QC-enabled terminal
devices with different rmware versions, it can
happen that the function is not fully supported.
Warning
• Only connect the product to a socket that has
been approved for the device. The socket must
be installed close to the product and easily
accessible.
• Disconnect the product from the network using
the power button – if this is not available,
unplug the power cord from the socket.