Klarstein Hot Spot Pebble Bedienungsanleitung Seite 27

4. Press the EDIT button
maximum 6 time periods). Such as setting P1: see display C on the picture below.
5. Press the TIME/ON button
ON button continuously to set the turn-on time. Such as set the turn-on time
7:00 AM (Memo: the setting time 0-24 for choice), see display C on the picture
below.
6. Press the TIME/OFF button
by default. Press the TIME/OFF button
Such as set the shutdown time at 13:00 PM (see display E on the picture below).
Note: Turn-off time is later than turn-on time. When turn-on time is the same
as turn-off time, the appliance is in stand by mode
7. Repeat steps 2-6 above, you can set the whole weekly program (Each day, the
work of each segment opens, the time of shutdown).
8. After above setting, press the DAY button
week. Press the EDIT button
the button or , to set desired temperature (temperature range: 10-49 °C).
Press the OK button
9. To cancel the weekly function, press the P button
weekly program is off. The appliance will revert to the previous function working
status.
NOTES:
After the above setting are completed and P program is working, press the DAY button
and the EDIT button
 The turn-on time periods 00-24 hours, cannot set to minutes.
The "TIME/OFF" can not be less than "TIME/ON".

 When the "TIME/ON" is the same as "TIME/OFF", the time period enters into
standby mode.
Note: If main switch off, power cut off, or plug out, it need reset. You can press the
SET button to check you set Time/Day.
. The display shows P1-P6 (for each day, it can be set
. The display shows 00"as default. Press the TIME/
. The display shows the previous step turn-on time
continuously to set the turn-off time.
to choose the unit turn-on day of the
to choose the turn-on time of the day. Then press
to confirm the setting.
to check the setting time of each day and time periods.
. The light "P" will go off. The
EN
27