What To Do If - Electrolux IK2755RE Benutzerinformation

60 www.electrolux.com

6. WHAT TO DO IF...

During operation of the appliance some
smaller but annoying trouble can often oc-
cur, which does not require calling a tech-
nician out. In the following chart informa-
tion is given about them to avoid unnec-
essary charges on service.
The operation of the appliance
goes with certain sounds (com-
pressor and circulating sound).
This not means a trouble, but a
normal operation.
Problem
The compressor op-
erates continually
Water flows at the
back plate of the re-
frigerator
Water flows into the
refrigerator com-
partment
Water flows onto the
floor
The lamp does not
work.
It is too warm in the
refrigerator
Possible cause
The Temperature Regula-
tor may be set incorrectly
The door does not close
tightly or it is not shut
properly
The door has been
opened too frequently
Food placed in the appli-
ance was too warm
The temperature of the
room that contains the ap-
pliance is too high for effi-
cient operation
During automatic defrost-
ing, frost melts on the
back plate
The outlet can be clogged
up
Products placed in can
prevent water from flowing
into the collector
The melting water outlet
flows not into the evapora-
tive tray above the com-
pressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regula-
tor may be set incorrectly
The appliance operates discontin-
uously, so the stopping of com-
pressor does not mean being no
current. That is why you must not
touch the electrical parts of the
appliance before breaking the cir-
cuit.
Solution
Set a warmer temperature
Check if the doors close
well and the gaskets are
undamaged and clean
Do not leave the door open
longer than necessary
Allow food to cool to room
temperature before storing
Try to reduce the tempera-
ture in the room where the
appliance stands
It is normal
Clean the outlet
Replace the products so
that they can not touch the
back plate directly
Put the melting water outlet
to the evaporative tray
Close and open the door.
Refer to "Replacing the
lamp".
Set a lower temperature