Bypass Function; Settings; Time; Control Valve - Honeywell PW50AS Einbauanleitung

8.4 "Bypass" function
8.4.1 "Bypass" position (Fig. 2)
In this position the raw water is not softened. The raw
water runs, via the bypass valve, through the
connection adaptor back into the drinking water supply.
8.4.2 "Service" position (Fig. 2)
In this position the raw water is softened and blended
with hard water as to the setting of the blending
adjuster.
8.4.3 Start-Up operation
For the first 1-2 week running period the brand-new
water conditioning device is in start-up operation.
During this period noise development can occur during
regeneration but will automatically disappear after ap-
prox. 1-2 weeks.

9. Settings

9.1 Time

Input: 24-hour mode
i
1. Set the time via the
The clock runs quicker when the
tons are held pressed.
Time

9.2 Control valve

All settings at the control valve have to be ente-
i
red in the check list!
WARNING!
Incorrect parameter changes can lead to sub-
stantial property damages!
In order to accept changes for the control valve
i
settings, run the programming until the end ☞
proceed with the
9.2.1 Capacity setting
1. Simultaneously press the
seconds.
CAUTION!
If is displayed, press no further
buttons (test mode manufacturer)!
Wait for approx. 10 seconds until the current
time is redisplayed!
2. Enter the calculated set value via the
buttons.
3. Press the button once to go to the next setting.
Honeywell GmbH
and buttons.
and but-
button!
and buttons for 5
and
GB
Note:
In operation or water consumption the residual capaci-
ty is reduced from the set amount to zero.
Residual volume 530 litres Residual volume 0 litres
9.2.2 Time-delayed, volume-controlled regenerati-
on
Regeneration is triggered at the set time if the remai-
ning capacity does not suffice for the next full day.
Set to 2.00 a.m. at the factory!
i
Input: 24-hour mode
Time regeneration
1. Press the and
2. Press the button once to go to the next setting.
9.2.3 Forced regeneration
Note:
If the programmed number of days between two rege-
nerations has been reached, a forced regeneration is
triggered at the set time. The forced regeneration is
triggered irrespective of the residual volume.
Set to 14 days at the factory!
i
Input: OFF up to 99 days
Forced regeneration
1. Press the and
ber of days.
2. Press the button once to accept all the chan-
ges.

9.3 Manual regeneration

There are two manual regeneration possibilities avai-
lable.
st
1 Possibility
Press the button
Manual regeneration starts immediately.
nd
2 Possibility
Press the button
Manual regeneration starts at the set time
(☞ Chapter 9.2.2)
Operating display flashes(☞ Chapter 8.1)
i
13
buttons to change the time.
buttons to change the num-
for 5 seconds.
for a short time.
MU1H-1408GE23 R0705