Chapter 5: Setting Up The Wireless-G Range Expander Running The Setup Wizard; Figure 5-3: Confirm Wireless Network Settings; Figure 5-5: Choose The Access Point; Figure 5-6: Configure Wireless Settings Manually - Cisco Systems Linksys WRE54G Benutzerhandbuch

Wireless-G Range Expander
4. When using a wired connection, the Setup Wizard will run a search for your wireless network. If found,
you will be asked to confirm the settings. If the settings are correct, click Yes and proceed to step 7. If
you'd like to choose a different wireless network, proceed to step 5.
If no wireless network is found, a screen will notify you when no access point is detected on your
network. Click Continue to survey your network for any access points or wireless routers, and proceed
to step 5. You can click Cancel to exit the Setup Wizard.
You will be notified if no wireless network is found. Make sure your wireless network is operational.
Then click Continue to run the search again, and proceed to step 5.
5. The site survey results will display all available access points and wireless routers in your network. Select the
one you want and then click Yes to continue. Then proceed to step 6.
You can click No to return to the Welcome screen of the Setup Wizard.
If you want to manually enter settings, click Manual. The Configure Wireless Settings Manually screen will
appear. Enter the SSID of your network. Then select the channel setting of your network.
If it does not use wireless security, select Disabled. Click Next to continue and proceed to step 7.
Chapter 5: Setting Up the Wireless-G Range Expander
Running the Setup Wizard
Figure 5-3: Confirm Wireless
Network Settings

Figure 5-5: Choose the Access Point

Figure 5-6: Configure Wireless Settings Manually

Figure 5-4: Wireless Network
Not Found
11