Inhaltsverzeichnis
Werbung
LECTUS duo 3000 readers
3.3
Troubleshooting
In case of malfunction of the reader, check these points:
–
Is the correct power supply on the plugs of PIN 1 (8.5 VDC to 16
VDC) and PIN 2 (0 V)?
–
If the reader is on Wiegand mode, DIP switch 1 must be set to the
OFF position.
–
If the reader is on OSDP/RS485 mode, DIP switch 1 must be set to
the ON position.
–
Set the address of the reader by setting the DIP switches 5 to 8
( Setting the address of the reader (Switch 5, Switch 6, Switch 7,
Switch 8), page 33 ).
Check the wiring between the reader and the controller ( Wiring the
–
reader, page 28 ).
Bosch Security Systems B.V.
35
Connection | en
2020-10 | V02 |
Werbung
Inhaltsverzeichnis
